Car Bottom Annealing Furnace

This car-bottom annealing furnace, designed and built by EPS for a large steel fabricator, is used to anneal large weldments, where the load weight can be up to 7500 lbs.

Email this page:

The unit is direct gas fired, with burners high on one side and low on the other, providing a top operating temperature of 1250F. The self-propelled load car rides on rails set in the floor, and is L-Shaped, with its back vertical wall becoming the front of the furnace when the car is driven fully into the chamber. Three control zones allow for a close control over uniformity in the chamber.

Please Call for Specs

+1 (888) 663-8038

  • Hidden
  • This field is for validation purposes and should be left unchanged.